No items found.
IR Emitter Covers, 5 Pack

These Emitter Covers are ideal for securing an emitter head to the device it is meant to control. Once the exact location of the emitter sensor is determined, place an emitter cover over the sensor head to secure it permanently to the device.

$ 6.95 USD
Product Info

These Emitter Covers are ideal for securing an emitter head to the device it is meant to control. Once the exact location of the emitter sensor is determined, place an emitter cover over the sensor head to secure it permanently to the device. If you are not sure that you have located the sensor there are various methods to determine this such as: 1. The User Guide of the device normally shows the IR sensor location on the front panel. 2. Holding a flashlight at an angle to the front panel will sometimes give an indication of the location. 3. When the device is on and while holding the emitter head, slide it slowly across the front panel while pressing a key on your remote. When the device responds the sensor has been found.

After the sensor location is found stick the emitter head over that location using the emitters self adhesive backing. Then, after testing this location and you are sure it is correct install the emitter cover using its self adhesive backing to hold the head permanently and reduce interference from other devices. Note: These covers are only for Emitter Heads. They are not to be used on IR Receiver heads. Receivers need line of sight access. Covering receivers with these covers will block the signal from your remote.

If you have any questions, please contact us at: http://www.universalremotes.net

MORE . . .
LESS . . .